Browsing Tahitian translation

31.

<b>User (User)</b>
<p>
The user the server runs under. Normally this
must be <b>lp</b>, however you can configure things for another user
as needed.</p>
<p>
Note: the server must be run initially as root to support the
default IPP port of 631. It changes users whenever an external
program is run...</p>
<p>
<i>ex</i>: lp</p>

32.

<b>Group (Group)</b>
<p>
The group the server runs under. Normally this
must be <b>lpadmin</b>, however you can configure things for another
group as needed.</p>
<p>
<i>ex</i>: lpadmin</p>

33.

<b>RIP cache (RIPCache)</b>
<p>
The amount of memory that each RIP should use to cache
bitmaps. The value can be any real number followed by "k" for
kilobytes, "m" for megabytes, "g" for gigabytes, or "t" for tiles
(1 tile = 256x256 pixels). Defaults to "8m" (8 megabytes).</p>
<p>
<i>ex</i>: 8m</p>

34.

<b>Temporary files (TempDir)</b>
<p>
The directory to put temporary files in. This directory must be
writable by the user defined above! Defaults to "/var/spool/cups/tmp" or
the value of the TMPDIR environment variable.</p>
<p>
<i>ex</i>: /var/spool/cups/tmp</p>

35.

<b>Filter limit (FilterLimit)</b>
<p>
Sets the maximum cost of all job filters that can be run
at the same time. A limit of 0 means no limit. A typical job may need
a filter limit of at least 200; limits less than the minimum required
by a job force a single job to be printed at any time.</p>
<p>
The default limit is 0 (unlimited).</p>
<p>
<i>ex</i>: 200</p>

36.

<b>Listen to (Port/Listen)</b>
<p>
Ports/addresses that are listened to. The default port 631 is reserved
for the Internet Printing Protocol (IPP) and is what is used here.</p>
<p>
You can have multiple Port/Listen lines to listen to more than one
port or address, or to restrict access.</p>
<p>
Note: Unfortunately, most web browsers don't support TLS or HTTP Upgrades
for encryption. If you want to support web-based encryption you will
probably need to listen on port 443 (the "HTTPS" port...).</p>
<p>
<i>ex</i>: 631, myhost:80, 1.2.3.4:631</p>

37.

<b>Hostname lookups (HostNameLookups)</b>
<p>
Whether or not to do lookups on IP addresses to get a
fully-qualified hostname. This defaults to Off for performance reasons...</p>
<p>
<i>ex</i>: On</p>

38.

<b>Keep alive (KeepAlive)</b>
<p>
Whether or not to support the Keep-Alive connection
option. Default is on.</p>
<p>
<i>ex</i>: On</p>

39.

<b>Keep-alive timeout (KeepAliveTimeout)</b>
<p>
The timeout (in seconds) before Keep-Alive connections are
automatically closed. Default is 60 seconds.</p>
<p>
<i>ex</i>: 60</p>

40.

<b>Max clients (MaxClients)</b>
<p>
Controls the maximum number of simultaneous clients that
will be handled. Defaults to 100.</p>
<p>
<i>ex</i>: 100</p>