Browsing Kannada translation

53.

The pack command packs the given snap-dir as a snap and writes the result to
target-dir. If target-dir is omitted, the result is written to current
directory. If both source-dir and target-dir are omitted, the pack command packs
the current directory.

The default file name for a snap can be derived entirely from its snap.yaml, but
in some situations it's simpler for a script to feed the filename in. In those
cases, --filename can be given to override the default. If this filename is
not absolute it will be taken as relative to target-dir.

When used with --check-skeleton, pack only checks whether snap-dir contains
valid snap metadata and raises an error otherwise. Application commands listed
in snap metadata file, but appearing with incorrect permission bits result in an
error. Commands that are missing from snap-dir are listed in diagnostic
messages.

When used with --append-integrity-data, pack will append dm-verity data at the end
of the snap to be used with snapd's snap integrity verification mechanism.

54.

The paths command prints the list of paths detected and used by snapd.

55.

The portal-info command returns information about a process in keyfile format.

This command is used by the xdg-desktop-portal service to retrieve
information about snap confined processes.

56.

The prefer command enables all aliases of the given snap in preference
to conflicting aliases of other snaps whose aliases will be disabled
(or removed, for manual ones).

57.

The prepare-image command performs some of the steps necessary for
creating device images.

For core images it is not invoked directly but usually via
ubuntu-image.

For preparing classic images it supports a --classic mode

58.

The publisher of snap %q has indicated that they do not consider this revision
to be of production quality and that it is only meant for development or testing
at this point. As a consequence this snap will not refresh automatically and may
perform arbitrary system changes outside of the security sandbox snaps are
generally confined to, which may put your system at risk.

If you understand and want to proceed repeat the command including --devmode;
if instead you want to install the snap forcing it into strict confinement
repeat the command including --jailmode.

59.

The quota command shows information about a quota group, including the set of
snaps and any sub-groups it contains, as well as its resource constraints and
the current usage of those constrained resources.

60.

The quotas command shows all quota groups.

61.

The reboot command can used from allowed hooks to control the reboot behavior of the system.

Currently it can only be invoked from gadget install-device during UC20 install mode. After invoking it from install-device with --halt or --poweroff the device will not reboot into run mode after finishing install mode but will instead either halt or power off. From install-device the effect is therefore not immediate but delayed until the end of installation itself.

62.

The reboot command reboots the system into a particular mode of the selected
recovery system.

When called without a system label and without a mode it will just
trigger a regular reboot.

When called without a system label but with a mode it will use the
current system to enter the given mode.

Note that "recover", "factory-reset" and "run" modes are only available for the
current system.