Browsing Greek translation

18.

PURPOSE:
Check that system detects a microphone being plugged in
STEPS:
1. Prepare a microphone with a standard 3.5mm jack
2. Locate the microphone jack on the device under test.
Keep in mind that it may be shared with the headphone jack.
3. Run the test (you have 30 seconds from now on)
4. Plug the microphone into the appropriate jack
5. Unplug the device for subsequent tests.
VERIFICATION:
Verification is automatic, no action is required.
The test times out after 30 seconds (and fails in that case).

19.

PURPOSE:
Check that balance control works correctly on internal speakers
STEPS:
1. Check that moving the balance slider from left to right works smoothly
2. Click the Test button to play an audio tone for 10 seconds.
3. Move the balance slider from left to right and back.
4. Check that actual speaker audio balance follows your setting.
VERIFICATION:
Does the slider move smoothly, as well as being followed by the setting by the actual audio output?

20.

PURPOSE:
Check that balance control works correctly on external headphone
STEPS:
1. Check that moving the balance slider from left to right works smoothly
2. Click the Test button to play an audio tone for 10 seconds.
3. Move the balance slider from left to right and back.
4. Check that actual headphone audio balance follows your setting.
VERIFICATION:
Does the slider move smoothly, as well as being followed by the setting by the actual audio output?

21.

Test to detect audio devices after suspending 30 times.

22.

PURPOSE:
This test will check that internal speakers work correctly after suspending 30 times.
STEPS:
1. Make sure that no external speakers or headphones are connected
If testing a desktop, external speakers are allowed
2. Click the Test button to play a brief tone on your audio device
VERIFICATION:
Did you hear a tone?

23.

Play back a sound on the default output and listen for it on the default input, after suspending 30 times.

24.

This test will verify that the volume levels are at an acceptable level on your local system. The test will validate that the volume is greater than or equal to minvol and less than or equal to maxvol for all sources (inputs) and sinks (outputs) recognized by PulseAudio. It will also validate that the active source and sink are not muted. You should not manually adjust the volume or mute before running this test.

25.

Record mixer settings after suspending 30 times.

26.

Benchmark for each disk

27.

Run gtkperf to make sure that GTK based test cases work